Belvedere BV2100BK Guía de instalación descargar pdf (Pagina 2)

8. From the underside of the bowl, place the fiber

washer over the strainer body. Secure the

strainer body with the nut.

DO NOT OVERTIGHTEN.

When the

strainer

body is

tightened

securely to

the bowl,

clean off

any excess

plumber’s

putty.

NOTE: Do NOT use the Rubber Washer

included with the strainer.

6. Apply a liberal amount

of plumber’s putty

(available at most

hardware stores)

around the

top of the

drain

opening.

7. Place the

strainer body

in the opening,

and press

it into the

plumber’s putty.

PAGE 2 of 3

INSTALLING THE DRAIN ASSEMBLY

FIBRE

WASHER

BRACKET

BOWL

NUT

5. Install the wall bracket so that the offset is

31-

” from the finished floor.

Be sure the

bracket is level!

Leave the bracket

slightly loose.

Use the attached

template and mark

all five bolt holes.

(The bracket height shown

is suggested to obtain the

neckrest height

suitable for

most

stylists.

However,

the bracket

height may be varied

to suit personal preference.)

7. Mount the bowl onto the wall bracket by

lowering the back of the bowl into the wall

bracket.

Attach

the lower

bracket

to the wall.

TAILPIECE

9. Attach the gasket and tailpiece to the strainer

body. DO NOT OVERTIGHTEN.

GASKET

BOWL

10. Check to be sure the

bowl is level side-to-

side, then tighten

the four bolts

holding the upper

bracket. Level the bowl

front-to-back by either

raising or lowering the

“L” shaped bracket and

tighten the single bolt.

Connect the fixture to the

hot and cold supply lines.

Install the trap and connect

thedrain.Applyabeadof

silicone to the back edge of

the bowl to seal it to the wall.

TRAP

SUPPLY

LINES

BOWL

IMPORTANT NOTE: It is the responsibility of the

installer and/or the owner to be sure that the

installation conforms to all prevailing local plumbing

codes and regulations.

BRACKET

”

PLUMBER’S

PUTTY

DRAIN OPENING

STRAINER

BODY

PLUMBER’S

PUTTY

DRAIN

OPENING

See Page 3 for rough-in specifications.

APPLY SILICONE

HERE

1 2 3

Comentarios a estos manuales

Sin comentarios

Belvedere BV2100BK Guía de instalación Pagina 2

Comentarios a estos manuales

Relacionado con productos y manuales para No Belvedere BV2100BK